Error message when reading a Raddiodity DB25-D

[wb2bwu]

Read and Write from the CPS supplied by vendor works but I read want to use the MM7DBT Codeplug editor...
Here is a screenshot when I attempt to read from the radio:. See attached PNG file.
[

[wb2bwu]

I performed a factory reset on the radio and then was able to read from the radio. Finally, I made some changes to the codeplug editor and was able to make some changes.

I don't see where I can import the Ham contacts I downloaded previously from Radioid.net. I tried the import option from the menu, but it told me that the format of the file was incorrect.

[KN6UIY]

I was getting the same error message. Need to try the factory reset if it helped.

[KN6UIY]

Resetting to factory defaults didn't help. Still getting the error on Windows 11.

Code: Select all

Read Failed.
Unable to find key ['Bitmask', 4989, 3, {0: 'CO', 1: 'TO', 2: 'SE'}] for val 0x3 - codeplug likely corrupted

Screenshot 2022-06-12 191322.png

[DO4OA]

I have that error, too.

I bought my device through Amazon. Some things were already configured on the device. For example, some DMR repeaters from Germany. Even after a factory reset, these configurations are still there.

73 & 55 DO4OA

[KN6UIY]

I have that error, too.

I bought my device through Amazon. Some things were already configured on the device. For example, some DMR repeaters from Germany. Even after a factory reset, these configurations are still there.

73 & 55 DO4OA

I bought mine directly from radioddity.com but it also has "not clean" code plug in it. Looks like a return device to me.

[VolkerSt]

Hi!

Same Problem here. My "new" Device looks like a return device too. Bought it from Amazon. And i cant read it with CPE. same error message as described above. I also cant read it with the original CPE from radioddity. No Communications. I will try to reset the device.

[VolkerSt]

Okey, reset the device, error still there. What FIrmware has to be installed on the device? Thanks.

[VolkerSt]

Okey, device now working with Original CPE. Alternative CPE still shows Error.
Any Solutions? The original CPE is... exhausting. Thanks.

[KN6UIY]

I was able to resolve the issue by re-flashing my radio with the firmware from the Radioddity support page.
I downloaded the "2022-03-11 CPS 3.3 - FW 2021-12-11 - CPEditor.rar" archive and used the firmware file version dated "Dec 11 2021"