MM7DBT Codeplug Editor

Tying to set VHF analog pt but no luck

Analog simplex programed CH 145.625/145.025 TX/RX tsq123
radio send out TX frq with subtone but no open rpt...rpt checked and works also tx on rt73 is ok and works correct frq and subtone pout...
Firmware 909E.D4.EARSAB.007. F136-460 JUN 102021


Tryed to import the CPS file into a Codeplug editor ... all fine...
aslo seen that in codeplug from radio was show (in cps on cp ) that ctss is tsq123 but in Code editor was shown DCS 17 ??? did not have luck to set it via CPS editor.... due showed issue... error.or somethinh...finaly wit manual entring on the radio set ctss 123 on ch register and import from radio to cps... but still no work...it goes correct plit it tamsit tX rpt entering freq correct with subtone .. but no rpt engage... uff...flustrated...
...

Unhandled exception: Input string was not in a correct format.

Channel frequency used a fixed regional decimal separator, decimal point, so using a comma would cause the error.
I have now fixed this in the update.

Update to 0.2.0327.1
I have updated it to support a comma ',' or decimal point '.'

I am also getting this error after downloading it a short time ago. Looks Awesome, hope I can write to the radio soon.

I have nailed down the culprit, it is in APRS Settings. TX Tone must be set to off.