Error message when reading a Raddiodity DB25-D

[G0FAJ]

I am using a Kydera CDR 300UV. Should I be able to use this editor as I get a message that says that "index was outside the bounds of the array" after reading codeplug from the CDR300UV. I have not done a firmware update. I am very green with DMR .

[slapshot2213]

My DB25-D purchased earlier this year "smoked" a few weeks ago. Raddiodity replaced it under warranty. Kudos to them!! The replacement arrived a few days ago with the most current firmware, I think. It was dated 4/2022. I had been using the MM7DBT CPE with good success. The new radio displayed an error either reading from or writing to it. I had to revert the FW to version 2021-12-11 to get good read/write results. All seems good now. .